Ross CrossOver 16 Specifications download pdf (Page 53)

Hold

Allows you to place a command in a custom control

that will stop the custom control at the hold event.

You must press the custom control button again, or

use a GPI trigger, to continue the custom control.

Pause

Allows you to place a command in a custom control

that will stop a custom control at the pause event. The

length of the pause is set when the pause is inserted.

When holding the INSERT button, pauses are shown

as Px, where x is the length of the pause in frames.

Loop

Allows you to have a custom control run continuously

until stopped, or a Cancel/Cancel All custom control

command is executed from another custom control.

GPO

Allows you to trigger a pre-selected GPI output using

a custom control. The specic GPI output is set when

the GPO command is inserted.

CutKey

Allows you create a custom control that will cut keys

on or off. The specic key and whether the key is cut

on or off is set when the key cut command is inserted.

TrnKey

Allows you to create a custom control that will

transition keys on or off. The specic key and whether

the key is transitioned on or off is set when the key

transition command is inserted.

IncKey

Allows you to create a custom control that will

include a key with the next transition to take the key

on-air, or off-air. The specic key and whether it

should go on-air, or off-air is set when the include

key command is inserted.

Resume

Allows you to resume a particular custom control that

is at a hold. The specic custom control is set when

the resume is inserted. If the target custom control is

not at a hold even, the resume command will not start

the target custom control.

Cancel

Allows you to stop a particular custom control. The

specic custom control is set when the cancel is

inserted.

CancelAll

Allows you to stop all running custom controls.

State

Allows you to embed the entire state of the switcher

into a custom control. A state in a custom control

behaves just like a memory.

To Insert a Special Event into a Custom Control

A special function can be inserted into any existing

custom control, or used when creating a new custom

control.

Start recording or editing your custom control

where you want to insert the special event.

Press INSERT.

Use the INSERT knob to select the event you

want to insert.

You can also press and hold the INSERT button

and press the source button on the custom control

bus for the event you want to insert. The event

names are shown on the mnemonics.

•

Hold — press the Insert knob to insert a

hold event

•

Pause — use the Secs and Frames knobs

to enter the length of the pause event

•

Loop — press the Loop knob to loop the

custom control back to the beginning

•

GPO — use the Pin knob to select the GPI

output

•

CutKey — use the Key knob to select the

key, and the State knob to select whether

you want the key cut on or off

•

TrnKey — use the Key knob to select the

key, and the State knob to select whether

you want the key transitioned on or off

•

IncKey — use the Key knob to select the

key, and the State knob to select whether

the key should be transitioned on-air or

off-air with the next transition

•

Resume — use the Bank knob to select the

custom control bank, and the CC knob to

select which custom control to resume

Carbonite Operation Manual (v8.0) — Custom Controls • 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 62 63

Comments to this Manuals

No comments

Ross CrossOver 16 Specifications Page 53

Comments to this Manuals

Related products and manuals for Cars Ross CrossOver 16